Occupational Safety and Health Standards: Materials Handling and Storage, Helicopters.

If you are the victim of construction accidents, use this page to conduct research. To have your case evaluated immediately, please fill out our form. Read more about the Occupational Safety and Health Standards, 1910.183, Materials Handling and Storage, Helicopters..

1910.183(a)

[Reserved]

1910.183(b)

Briefing. Prior to each day's operation a briefing shall be conducted. This briefing shall set forth the plan of operation for the pilot and ground personnel.

1910.183(c)

Slings and tag lines. Loads shall be properly slung. Tag lines shall be of a length that will not permit their being drawn up into the rotors. Pressed sleeve, swedged eyes, or equivalent means shall be used for all freely suspended loads to prevent hand splices from spinning open or cable clamps from loosening.

1910.183(d)

Cargo hooks. All electrically operated cargo hooks shall have the electrical activating device so designed and installed as to prevent inadvertent operation. In addition, these cargo hooks shall be equipped with an emergency mechanical control for releasing the load. The employer shall ensure that the hooks are tested prior to each day's operation by a competent person to determine that the release functions properly, both electrically and mechanically.

..1910.183(e)

1910.183(e)

Personal protective equipment.

1910.183(e)(1)

Personal protective equipment shall be provided and the employer shall ensure its use by employees receiving the load. Personal protective equipment shall consist of complete eye protection and hardhats secured by chinstraps.

1910.183(e)(2)

Loose-fitting clothing likely to flap in rotor downwash, and thus be snagged on the hoist line, may not be worn.

1910.183(f)

Loose gear and objects. The employer shall take all necessary precautions to protect employees from flying objects in the rotor downwash. All loose gear within 100 feet of the place of lifting the load or depositing the load, or within all other areas susceptible to rotor downwash, shall be secured or removed.

1910.183(g)

Housekeeping. Good housekeeping shall be maintained in all helicopter loading and unloading areas.

1910.183(h)

Load safety. The size and weight of loads, and the manner in which loads are connected to the helicopter shall be checked. A lift may not be made if the helicopter operator believes the lift cannot be made safely.

1910.183(i)

Hooking and unhooking loads. When employees perform work under hovering craft, a safe means of access shall be provided for employees to reach the hoist line hook and engage or disengage cargo slings. Employees may not be permitted to perform work under hovering craft except when necessary to hook or unhook loads.

..1910.183(j)

1910.183(j)

Static charge. Static charge on the suspended load shall be dissipated with a grounding device before ground personnel touch the suspended load, unless protective rubber gloves are being worn by all ground personnel who may be required to touch the suspended load.

1910.183(k)

Weight limitation. The weight of an external load shall not exceed the helicopter manufacturer's rating.

1910.183(l)

Ground lines. Hoist wires or other gear, except for pulling lines or conductors that are allowed to "pay out" from a container or roll off a reel, shall not be attached to any fixed ground structure, or allowed to foul on any fixed structure.

1910.183(m)

Visibility. Ground personnel shall be instructed and the employer shall ensure that when visibility is reduced by dust or other conditions, they shall exercise special caution to keep clear of main and stabilizing rotors. Precautions shall also be taken by the employer to eliminate, as far as practical, the dust or other conditions reducing the visibility.

1910.183(n)

Signal systems. The employer shall instruct the aircrew and ground personnel on the signal systems to be used and shall review the system with the employees in advance of hoisting the load. This applies to both radio and hand signal systems. Hand signals, where used, shall be as shown in Figure N-1.

..1910.183(o)

1910.183(o)

Approach distance. No employee shall be permitted to approach within 50 feet of the helicopter when the rotor blades are turning, unless his work duties require his presence in that area.

1910.183(p)

Approaching helicopter. The employer shall instruct employees, and shall ensure, that whenever approaching or leaving a helicopter which has its blades rotating, all employees shall remain in full view of the pilot and keep in a crouched position. No employee shall be permitted to work in the area from the cockpit or cabin rearward while blades are rotating, unless authorized by the helicopter operator to work there.

1910.183(q)

Personnel. Sufficient ground personnel shall be provided to ensure that helicopter loading and unloading operations can be performed safely.

1910.183(r)

Communications. There shall be constant reliable communication between the pilot and a designated employee of the ground crew who acts as a signalman during the period of loading and unloading. The signalman shall be clearly distinguishable from other ground personnel.

1910.183(s)

Fires. Open fires shall not be permitted in areas where they could be spread by the rotor downwash.

FIGURE N-1 HELICOPTER HAND SIGNAL

(For Figure N-1, Click Here)

[40 FR 13440, Mar. 26, 1975; 63 FR 33450, June 18, 1998]

Act now! It is essential that you inquire about your case as soon as possible. Litigation may be the only way to receive the damages to which you may be entitled, such as medical and health care bills, lost or diminished wages, and financial compensation to family in the case of death. Your individual state's law may limit your time to bring a legal claim to protect your rights. You need to have your construction accidents claim evaluated immediately!

Click To Talk To Us Online

see also:

Helicopters FREE construction accidents OSHA information: Helicopters.
construction accidents info: Materials Handling and Storage, Helicopters.

Powered industrial trucks FREE construction accidents OSHA information: Powered industrial trucks.
construction accidents info: Materials Handling and Storage, Powered industrial trucks.

Authority for 1910 Subpart N FREE construction accidents OSHA information: Authority for 1910 Subpart N
construction accidents info: Materials Handling and Storage, Authority for 1910 Subpart N